DJ Academy / Lesson

Using the mixer

  • Lesson 6 · Beginner
  • 10 minutes
  • +100 XP
  • Free

In this lesson you’ll…

  • Use a volume fader to control how loud each deck is
  • Describe what the high, mid and low EQ knobs do
  • Cut and restore the bass of a track with the low EQ
  • Set the master volume to a safe, comfortable level

The mixer is the control centre of your setup. Every sound from both decks passes through it before it reaches the speakers, so learning the mixer is how you go from playing tracks to actually mixing them.

Channels and volume faders

The mixer has one channel for each deck: blue for Deck A and pink for Deck B. Each channel has a volume fader (also called a channel fader). Push it up to make that deck louder; pull it down to make it quieter. Many DJs bring in a new track by slowly raising its fader.

On club mixers you will also see a gain knob at the top of each channel. Gain sets each track’s starting loudness so two tracks match before you touch the faders. The level meters should bounce mostly in the green, never sitting in the red.

EQ: shaping the sound

EQ is short for equaliser. Each channel has three EQ knobs:

  • High controls bright, sparkly sounds like hi-hats and cymbals.
  • Mid controls the middle sounds like vocals, keys and synths.
  • Low controls the bass and the thump of the kick drum.

The middle position (12 o’clock) is neutral. Turning a knob left cuts that sound and turning it right boosts it. DJs cut much more often than they boost. When two tracks play together, cutting the bass on one stops the two basslines turning into a muddy rumble.

Master volume and your ears

The master knob controls the volume of the whole mix. Set it so the music sounds full but comfortable, with room to talk over it. If you use headphones, start with them turned down low and raise them slowly. Take a break every half hour or so, and if your ears ring, stop and give them a rest.

Try this: Play one track and slowly turn the low EQ all the way down, then back up. Repeat with the mid and high knobs and describe what disappears each time.

Guided practice in the studio

DJ Kiddo walks you through these steps in the DJ Studio:

  1. Play Deck A Press Play on Deck A. Everything you hear is now flowing through the mixer.
  2. Ride the fader Slide Deck A's blue volume fader down until the track is quiet, then push it back up to the top.
  3. Cut the bass Turn Deck A's low EQ knob all the way to the left. The kick drum and bassline disappear!
  4. Bring it back Turn the low knob back to the middle (12 o'clock) so the bass returns. Press Next when it sounds normal again.
  5. Try the highs Turn the high EQ knob to the left. The bright hi-hats fade away. Set it back to the middle when you are done.
  6. Try the mids Turn the mid EQ knob to the left. The chords and melody get quieter. Set it back to the middle afterwards.
  7. Silence Deck B Pull pink Deck B's volume fader all the way down. That deck now stays silent until you raise it, which is handy when mixing.
  8. Safe volume Set the master volume so the music sounds full but you could still chat over it. That is a safe level for your ears.
  9. Mixer master Nice work! You used a volume fader, all three EQ knobs and the master. Remember to take regular listening breaks.

Practise in the Studio

Quick quiz

Pick an answer to see if you’re right. Get them all for +25 bonus XP!

1. Which EQ knob controls the bass and kick drum?
2. Why do DJs often cut the bass on one track when two are playing?
3. What should you do if your ears start ringing?

Want to earn XP and badges for this lesson? Ask a grown-up to create a free account.